Requirements for transverse bar are as follows—

(dimensions used on sketches are guidelines only, different model, weight range, tray size, long and short wheel base construction are the factors that will determine final measurements)

• (a)the following weight range and dimensions are to be used as a guideline—

  DIMENSION	2–2.5 TON	2.5–4.5 TON	4.5–5
  A–B	1550 mm	1800 mm	1950 mm
  C–D	1160 mm	1350 mm	14705 mm
  D–E	120 mm	150 mm	100 mm
  E–F	140 mm	170 mm	170 mm
  G–H	1320 mm–max 1600	1750 mm–max 2000	1800 mm–max 2000

• (b)The angles and bends on transverse bars from end elevation shown below apply to all vehicles regardless of weight—

Note:

Angle Flexibility

A = 130–155 deg

B = 110–115 deg

• (c)The following longitudinal bars settings as shown from a side elevation—
• (d)The following transverse, longitudinal bars, emergency exit and luggage compartment settings from side elevation and also shown from plan view, are required—

  Transverse and longitudinal bars settings from plan view

  
• (e)The requirements for the longtidunal and transverse bars affixing point from end view are shown in the following diagram—
• (f)The following dimensions on weight range are to be used as a guideline—

  LONGITUDINAL BAR SPACING	2–2.5 TON	2.5–4.5 TON	4.5–5 TON
  A–B BAR	300 mm	300 mm	300 mm
  B–C	580 mm	670.5 mm	730.5 mm
  C–D	580 mm	670.5 mm	730.5 mm
  D–E	120 mm	150 mm	160 mm